Tapmatic Quill Mount Torque Bar, 38 – 60mm (1-1/2 – 2-3/8) Diameter, M16 (1/2) Capacity – 29099-TM
Tapmatic Quill Mount Torque Bar38 - 60mm (1-1/2 - 2-3/8") DiameterM16 (1/2") Capacity#29099 Quill Mount Torque Bars Clamp around quill of machine for use with Manual Tapping Always mount a torque bar to hold the tapping attachment's stop arm from rotating.
Tapmatic Quill Mount Torque Bar
38 – 60mm (1-1/2 – 2-3/8″) Diameter
M16 (1/2″) Capacity
#29099
Quill Mount Torque Bars Clamp around quill of machine for use with Manual Tapping
Always mount a torque bar to hold the tapping attachment’s stop arm from rotating. The stop arm should not be installed permanently, not under any circumstances be held by hand or fastened with wire. The torque bar must be mounted securely to the table or quill of your machine. The torque bar installation must be stronger than the largest tap in the capacity range of your tapping attachment. Please order Tapmatic torque bars shown.
Specifications:
See all Tapmatic Quill Mount Torque Bars
Reviews
There are no reviews yet.